Latest activity Postings Media About
-
-
mas985 replied to the thread Does a salt cell require higher chlorinator % setting as it gets older to maintain same FC level?.Yes At 50%, the cell should run for 90 minutes. You might want to time that. Which controller do you have? Also, if you are comparing... -
mas985 replied to the thread Extending life of Gunite pool.Gunite lasts pretty much forever. That is the concrete base that plaster is put on. I think you may be referring to plaster skin coat...
-
mas985 replied to the thread Air Relief Tube Filter - Hayward SwimClear.Is the tube still there and just the filter missing or the whole thing is missing? Either way, yes, just debris getting past although it...
-
mas985 replied to the thread Air Relief Tube Filter - Hayward SwimClear.The air relief tube is on the debris side of the filter and it's main purpose is to allow air to escape from the filter out the returns...
-
mas985 replied to the thread low pressure and lots of air.The teflon tape can crack the union threads so you should avoid using that. If the o-rings don't seal on their own, they should be replaced.
-
mas985 replied to the thread low pressure and lots of air.Doesn't the union have o-rings? It shouldn't need teflon tape.
-
thanks all everything seems to be better now. I did undo the union on suction side of pump and cleaned it and put teflon tape on threads...
-
mas985 replied to the thread low pressure and lots of air.The gauge could be bad and that is why you are reading lower than normal pressure. Let's focus on the air leak. I think I posted this...
-
mas985 replied to the thread Extending life of Gunite pool.That could be delamination and is an indication of poor application. If anything that might shorten the life of the pool. @onBalance...
-
mas985 replied to the thread low pressure and lots of air.That is a single speed uprated 3/4 HP (0.9525 THP) pump. It looks like it might be a Sta-Rite Dynamo above ground pool pump...
-
-
mas985 replied to the thread Intelliflo power consumption.Pump VS motors use a VFD (variable frequency drive) which generate a pseudo 3-phase AC waveform using pulse width modulation (PWM) and...
-
-
-
mas985 replied to the thread Intelliflo power consumption.Reduce RPM and power will go done. Why do you need such a high RPM? Heater, SWG? 1000 RPM is usually going to be the most efficient...
-
mas985 replied to the thread low pressure and lots of air.Is there a switch on the back of the pump? Take a picture of the pump motor label.
-
-
Loading…
-
Loading…
-
Loading…
