Recent content by 04cobraboy

It's making sense to me now. So you use a HVR relay to control the 24v relay. Then just program the HVR for whatever you want to call it or program it as. That's what i was trying to figure out was what is controlling or signaling the 24v relay. This is easily doable. Do you have a link to a...

Sorry I replied but edited this reply. I didn’t see your reply Jim now I do. Gotcha makes sense. Are you aware which signal has 24v? Is it the LS bus bar?

I can figure a way to mount it that’s not an issue. I assume it has to have a signal to close and to open or it moves back to the original position once it is turned on or off depending how it’s set up?

Sorry for multiple reply’s but if I do set it up this way can I still control the valve from the automation board via my phone from an open input source off the panel or no?

Do you have a link to this auxiliary relay?

Makes sense. So I need a separate transformer or I can tie into 24v on the board somewhere? I do have two additional HVR slots left inside the panel.

New to this forum but I know someone in here has a confident solid answer. I’m going to contact Hayward on Monday for confirmation but here’s my question in a nutshell without explaining tons of detail. Need/want to add another actuator to my Omni PL system. Thing is there are 4 valves already...