Jandy AquaPure EI APURE35 SWG breather tube

[IkigaiYay]

I asked Jandy about this, and they weren't interested in helping.

What is the correct positioning and orientation of the breather tube?

Should the end with the angled cut be on the top or bottom?

Should the angled cut face the pool (outlet) or the pump (inlet)?

How high relative to the top of the plates should the top of the tube be positioned?

What are the effects of that tube being a little too high or a little too low?

 

[1poolman1]

I asked Jandy about this, and they weren't interested in helping.

What is the correct positioning and orientation of the breather tube?

Should the end with the angled cut be on the top or bottom?

Should the angled cut face the pool (outlet) or the pump (inlet)?

How high relative to the top of the plates should the top of the tube be positioned?

What are the effects of that tube being a little too high or a little too low?

Angle at the top. Why? I don't know, that's how the manufacturer does it. Probably helps evacuate the air. faster.
It is there to make sure that any air in the system does not allow the top of the plates to be uncovered as the water (and any air) flows through the cell. Too low and the plates can be uncovered.

 

[JamesW]

 

[JamesW]