Hayward SPX3200A Pump Strainer Housing Replaced - Please help!

Jump to latest Follow Reply
Do you have a multimeter and know how to use it?

Have you checked for voltage between L1 and L2 at the pump?

Post pictures of your pump and what you did.
 
andydufresne said:
Hi friends,
I replaced my leaky strainer housing yesterday using the @Yeller989 tutorial. Everything went well until I turned the power back on and the pump would not power up. Any thoughts on what I may be missing? Thanks in advance!
Click to expand...
Unless you removed the motor from the electrical supply, which there was no need to do, it is probably a tripped breaker or a wire that came loose in the wiring compartment from the pump being disturbed. Turn the breaker for the pump off, open the compartment (one screw on the top of the drive, look at the wiring. If it is intact, you need to use a multimeter to find where the power stops. At the relay? Does it get through the relay? At the pump itself (is there 240V at the pump)?
 
You must log in or register to reply here.
Thread Status
Hello , This thread has been inactive for over 60 days. New postings here are unlikely to be seen or responded to by other members. For better visibility, consider Starting A New Thread.
Top Bottom
Back
Jump to latest Follow Reply