Hi, TFP family!
A few days ago, during a very sunny period, my pool stopped reporting temperature (the reading was “open”) and my SWG started showing 0% production (picture attached).
Just to be sure my recent addition of calcium chloride hadn’t scaled up the salt cell, I removed and cleaned it (it looked clear, but I did the usual diluted muriatic acid & water soak). No effect.
Before I call for a repair, I wanted to see if you all had any recommendations.
Pool setup is described below, along with the most recent Taylor test results (chlorine is at this level because I added some liquid bleach):
FC: 2.6
CC: 0
pH: 7.7
TA: 70
CH: 410
CYA: 70
Salt: 4000 (this is puzzling—I test with the Taylor kit and, without adding any salt, it’s risen from 3000 to 4000; on the panel, however, it says 3300)
A few days ago, during a very sunny period, my pool stopped reporting temperature (the reading was “open”) and my SWG started showing 0% production (picture attached).
Just to be sure my recent addition of calcium chloride hadn’t scaled up the salt cell, I removed and cleaned it (it looked clear, but I did the usual diluted muriatic acid & water soak). No effect.
Before I call for a repair, I wanted to see if you all had any recommendations.
Pool setup is described below, along with the most recent Taylor test results (chlorine is at this level because I added some liquid bleach):
FC: 2.6
CC: 0
pH: 7.7
TA: 70
CH: 410
CYA: 70
Salt: 4000 (this is puzzling—I test with the Taylor kit and, without adding any salt, it’s risen from 3000 to 4000; on the panel, however, it says 3300)