Hi all,
I just got the Typhoon slide. It is all installed. The bottom section joint is about 1/8” to 1/4” lower than the top of the slide section on one side. It’s very painful when going down the slide as it causes quite a bump. Seems to be just poor manufacturing.
How can I fix this? Is the slide hollow or solid? Can I take a dremel tool to shave it down to better line up? Other ideas? Thanks.
I just got the Typhoon slide. It is all installed. The bottom section joint is about 1/8” to 1/4” lower than the top of the slide section on one side. It’s very painful when going down the slide as it causes quite a bump. Seems to be just poor manufacturing.
How can I fix this? Is the slide hollow or solid? Can I take a dremel tool to shave it down to better line up? Other ideas? Thanks.