My contractor just finished installing a new 12,000 gallon fiberglass pool along with an enclosure and equipment. Part of the job was an Aquarite 900 and there may be some issues with it.
1) first they added too much salt. The level was 4900, way over the recommended level of up to 3400. I would have expected the high salt light to come on but it didn't.
2) and now I realized that the low flow light won't come on either when I lower the pump speed to the minimum (600rpm) or even turn it off. I would expect that with no flow at all, the light would come on. If unplug the cable from the box, the light does come on, so the LED is not burnt out.
I've looked online for answers but all I find is troubleshooting for when the lights are on, not about them not coming on when they should. And I'm trying to avoid asking the contractor until I know this is not something I'm missing. This project has been a very rocky road. Any ideas for what's going on?
1) first they added too much salt. The level was 4900, way over the recommended level of up to 3400. I would have expected the high salt light to come on but it didn't.
2) and now I realized that the low flow light won't come on either when I lower the pump speed to the minimum (600rpm) or even turn it off. I would expect that with no flow at all, the light would come on. If unplug the cable from the box, the light does come on, so the LED is not burnt out.
I've looked online for answers but all I find is troubleshooting for when the lights are on, not about them not coming on when they should. And I'm trying to avoid asking the contractor until I know this is not something I'm missing. This project has been a very rocky road. Any ideas for what's going on?