How old is it? Three - five years is a good life depending on what percentage you have it set.It was time to clean the SWG, cleaned it up with diluted muriatic and the plates look great now. Hooked it back up and I’m getting the flashing CELL light for “inspect the cell “ do I need a new SWG?
3/18/2020Show the label on the backside of the cell.
If you run your pool and SWG 8 hours a day at 100% that is nearly 9000 hours for the three years. That is nearly the average life span of a salt cell. With a VSP you likely run it longer.3 years, Gets all the AZ sun and was usually sitting at 100% to keep up
When you do the CYA test, try this next time.I always have a hard time with the CYA and watching that dot disappear in the tube.
The "CELL" light will only illuminate when it's actively producing chlorine. It runs on a 5 minute cycle. For example, if set to 60%, the cell will generate for three minutes, then idle for two minutes, then repeat.I just installed the new IC60 and everything went smooth. But now there is no light in the status area. What could cause that
Thanks so muchThe "CELL" light will only illuminate when it's actively producing chlorine. It runs on a 5 minute cycle. For example, if set to 60%, the cell will generate for three minutes, then idle for two minutes, then repeat.