Recent content by Walter2050

I added in a sock and put the sock in the skimmer and periodically I go and squeeze the sock to help it dissolve faster. It fully dissolves in the skimmer before reaching the filter .

Just added about 2 pounds of cya to my pool . How long do I need to wait before I clean my cartridge filters ?

Thank you . After the rain storm passes I will do the test

Not quite sure how that is performed. Is there a link for that ? I do know when I put it in boost mode it does generate chlorine

Yes

Thank you sir . Being that my water temperature isn’t below 51 degrees and is reading 53 could that be a bad sensor ?

After go through the freeze in Texas my jandy aquapure is still flashing LO. Temp outside is 66 and pool water temp is 53 . Does the system go off the outside temp or the water temp ? Also does anyone know what the cutoff temp is ?

Thank you . I just verified through the i aqua link that the spa was in freeze mode. It also had a setting to put spa blower in freeze mode . It was off . Should that be on freeze mode ?

Good evening getting ready for my first freeze with pool in Texas . I very familiar with my freeze protection on my jandy system but not sure if the system changes over to spa mode every so often . Does the system automatically do that ? Or is it something that needs to be in programing ? My...

It seems like the system would go by what the sensor is telling it than what the actual temp is ?

Thank you . Water temp is now 57 and Now it’s producing chlorine again

According to you link you sent it says Chlorine stops producing at a water temp of 51degrees . My water temp is 56 degrees

This is my first winter with my jandy aquapure 1400 swg . What temp does the Swg on aquapure stop,generating? My pool temp 56 degrees and on the display it is flashing from Lo to 10% . 10% is what I have set for chlorine production .

Thank you . Does the swg aleart you ( on the aqua link app )when it gets to that temp ?