Jandy Aquapure

[Walter2050]

After go through the freeze in Texas my jandy aquapure is still flashing LO. Temp outside is 66 and pool water temp is 53 . Does the system go off the outside temp or the water temp ? Also does anyone know what the cutoff temp is ?

 

[JamesW]

https://images.inyopools.com/cloud/documents/jandy-aqua-pure-error-codes.pdf

 

[Walter2050]

View attachment 551419

https://images.inyopools.com/cloud/documents/jandy-aqua-pure-error-codes.pdf

View attachment 551421

View attachment 551422


View attachment 551423

Thank you sir . Being that my water temperature isn’t below 51 degrees and is reading 53 could that be a bad sensor ?

 

[JamesW]

Being that my water temperature isn’t below 51 degrees and is reading 53 could that be a bad sensor ?

Is that the reading from the AquaPure box?

 

[Walter2050]

Is that the reading from the AquaPure box?

Yes

 

[JamesW]

Try the board test.

 

[Walter2050]

Try the board test.

Not quite sure how that is performed. Is there a link for that ? I do know when I put it in boost mode it does generate chlorine

 

[JamesW]

 

[Walter2050]

View attachment 551429

Thank you . After the rain storm passes I will do the test

 

[HermanTX]

Thank you sir . Being that my water temperature isn’t below 51 degrees and is reading 53 could that be a bad sensor ?

The sensor for the AquaPure are erratic. My salt reading by the AquaPure rarely aligns to the real salt level with the Taylor test kit. The water sensor that is in your PVC pipe can be inaccurate if old. It is good to replace it every couple of years.

Any time pool temperatures drop below 55 degrees F it is best to switch to Liquid Chlorine for the month or so. THer is no sense wearing out the SWCG when it is easy just to add LC every 5 days or so.