Jandy AquaPure SWG - Further Reading

Jandy AquaPure SWG

The Jandy AquaPure system consists of a AquaPure Power Center or PureLink Power Centers and either a PURE700 cell or a PURE1400 cell. The PureLink Power Centers combine all the features of the AquaLink Power Centers and AquaPure water purification electronics in one box.

The AquaPure salt-water chlorine sanitizing systems uses salt water to deliver water sanitation by generating chlorine.

The AquaPure cells can be controlled by the AquaPure control panel or Aqualink automation systems.

AquaPure Cell Capacity

The AquaPure system offers two cells that can generate different maximum amounts of chlorine in a 24 hour period. You use the % generation control to adjust the actual amount of chlorine generated to meet your pools chlorine need.

• PURE700 - 0.625 lb./24 Hr. (283 gm/24 Hr.)
• PURE1400 - 1.25 lb./24 Hr. (567 gm/24 Hr.)

Model Configuration

Both cells use the same Power Center box. However there is a jumper on the Power Interface Board that is connected for the 1400 cell and cut for the 700 cell. The Power Center comes configured for the 1400 cell and the JL1 jumper must be cut if using the 700 cell.

If you are switching from the 700 cell to the 1400 cell the JL1 jumper needs to be reconnected.

Page 17 in the Jandy Power Center Installation Manual shows the location of the jumper.

AquaPure Cycle Time

The AquaPure has a 3 hour cycle time. The percentage setting will control how much the cell runs during the cycle.

For example, at 50%, the box will say "Cell On" for 1.5 hours then "Cell Resting" for 1.5 hours. Then, there is a two minute off time, then the box will say Cell Reversing for 1.5 hours, then Cell Resting for 1.5 hours etc.

Jandy Warranty

Here is an excerpt from page 423 (892) of their 2019 catalog:

"This Jandy Limited Warranty does not apply to Jandy branded products purchased through the Internet or other e-commerce platforms, with the exception of Jandy branded valves, parts, and accessories. This warranty applies only to products installed and serviced by a contractor who is licensed and qualified in pool equipment by the jurisdiction in which the product will be installed, where such state or local requirements exists. In the event no such state or local requirement exists, the installer and maintainer must be a professional with sufficient experience in pool equipment installation and maintenance."

Here's another item of interest from p 877:

IMPORTANT NOTICE NO WARRANTY if purchased online. This is not a DIY product. Installation by a qualified pool professional required. Register product at Jandy.com/registration.

Troubleshooting

Jandy PDA not displaying AquaPure info

Many AquaPure display problems seem to get fixed by powering the Power Center and Aqualink panel if connected off at the circuit breakers, waiting a few minutes, and powering everything back on.

AquaPure Resets to 35% Everytime it is Powered On

A member had the problem of his Aquapure resetting to 35% every time it was powered on by the timer. After discussions with a Jandy representative it was determined the problem was a bad board.

Power Center Transformer

Older Power Centers use a rectangle transformer P/N T1005 that is no longer available. Currently, Jandy has part R0481400 which is the round transformer.

A member found that the new part fit perfectly with the same mounting holes. Even the High Voltage side wires were color coded identically. The only difference is the new part has a ground wire that was attached to the common ground.

• 

  Jandy T1005

• 

  Jandy R0481400

• 

  Jandy T1005

• 

  Jandy T1005 Burnt Plug