Hi,
I am new to the forum but have a very frustrating problem with my Zodiac LM3-24 salt water chlorinator controller. I have replaced the cell, the lead to the cell and the PCB that controls the programming and provides the interface.
The problem I have is that I have flow and no air in the system that is visible but the 'no flow' light comes on after an undetermined period after which I can only clear it by pressing the reset. I then have to re set the time and program again.
Any help or suggestions would be gratefully accepted. Its driving me mad!
I am new to the forum but have a very frustrating problem with my Zodiac LM3-24 salt water chlorinator controller. I have replaced the cell, the lead to the cell and the PCB that controls the programming and provides the interface.
The problem I have is that I have flow and no air in the system that is visible but the 'no flow' light comes on after an undetermined period after which I can only clear it by pressing the reset. I then have to re set the time and program again.
Any help or suggestions would be gratefully accepted. Its driving me mad!
