Ultra xtr frame dimple

chrissimmon

New member
Aug 4, 2021
2
Illinois
I just installed a 24x12 rectangular intex ultra xtr pool a couple weeks ago. We had a landscaper level the yard and put sound down and put the metal Fram on 2.75 inch concrete pavers and it's level all around within 1/4 to half inch. I noticed some very small dings or dimples on the frame legs already and wondering if this is normal or if I should be concerned. Might be hard to tell from the pic but didn't see any other posts on it so thought I'd ask if anyone else experienced this
 

Attachments

  • 20210814_084141.jpg
    20210814_084141.jpg
    201 KB · Views: 20

Mdragger88

Bronze Supporter
TFP Guide
Jun 1, 2018
5,088
Hernando, Ms
Pool Size
26000
Surface
Vinyl
Chlorine
Salt Water Generator
SWG Type
Intex Krystal Clear
Probably not a stability concern (dings happen) but if any of the finish is compromised you want to put some rust oleum paint on it asap so corrosion doesn’t occur. Creases are bad but that’s not looking like a problem for u. So long as everything is level & they aren’t a sign of buckling.
 
  • Like
Reactions: Pv2

chrissimmon

New member
Aug 4, 2021
2
Illinois
Probably not a stability concern (dings happen) but if any of the finish is compromised you want to put some rust oleum paint on it asap so corrosion doesn’t occur. Creases are bad but that’s not looking like a problem for u. So long as everything is level & they aren’t a sign of buckling.
Thanks for the quick reply.. No sign of buckling and the finish isn't compromised at all but I was just surprised to see the dimples just a couple weeks in where we put so much effort into the landscaping and leveling. We had to dig two feet on one side to get it level and had a retention wall built.
 
Thread Status
Hello , This is an inactive thread. Any new postings here are unlikely to be seen or responded to by other members. You will get much more visibility by Starting A New Thread