Thinking about switching from PVC pipe to flexible hose again

[EddieO]

When I got my AG pool several years ago. I replaced the hoses with PVC. Now I think I want to go back hoses again.
The reason is it seems every year the PVC doesn't line up to connect the pipe to the pump and filter. Possibly due to ground settling.
Do you use PVC or hose?
Eddie

 

[HermanTX]

Please read the section on Flex PVC in this article.

PVC Repair - Further Reading

www.troublefreepool.com

If all the flex pipe is above ground then you should be able to inspect and monitor it properly. So do what is easier for you.

 

[Mdragger88]

I have a mix of all 3 - flex pvc, rigid pvc, and hoses.
This is mainly due to the orientation of my pump/filter in relation to my pool,deck, and swcg.
I like being able to remove the hoses and pipes easily for the winter and have them tucked under the deck while in use but also not be in the way of my swg box or my storage area.
There’s no wrong answer- just do what works for you.

 

[Mdragger88]

Here’s a pic of my spaghetti lol


If I only had a top return the setup would be much simpler. When the pool was installed there was no deck and the pump/filter was closer to the pool. At that time I had an intex swcg unit attached to each return (so 4 hoses just for that).
The bottom return presents a winterizing challenge since I cannot plug it or unplug it from the inside of the pool with out going into shock in late October & march
it is also very close to the ground due to the pool being buried. This is why the valve is 1st then the 90 unlike the top return who’s pipe fits nicely against the wall. I can’t spin it off and on the other way.
I don’t love the look but oh well.
I had to come up with a way to shut it off so I could remove the plumbing at my leisure then afterwards quickly plug it from the outside without getting drenched.
*all my cables/cords are loosely hung right now - it usually looks neater than this