My Aqua Logic system shows "salinity too low" (zero), so SWG (Goldline T-Cell 15) is obviously off. However, when I tried to test salinity with the K-1766 Tailor kit, salinity apparently was so high that after 30 drops I still could not reach the color change, which means it is higher than 6000 ppm.
Why then the system shows salinity too low? Does the T-cell measure salinity? This would mean either the cell went bad or it just shut off because of high salinity - which is correct?
Is there a separate unit in the system that measures salinity? Then this unit could be bad and may be I do not need to replace a $600 T-cell.
I get the pool with the house, so I do not know how old the cell is, the pool was built in 2006. The T-cell inside shows just little yellow-orange coloration.
Any advice?
Why then the system shows salinity too low? Does the T-cell measure salinity? This would mean either the cell went bad or it just shut off because of high salinity - which is correct?
Is there a separate unit in the system that measures salinity? Then this unit could be bad and may be I do not need to replace a $600 T-cell.
I get the pool with the house, so I do not know how old the cell is, the pool was built in 2006. The T-cell inside shows just little yellow-orange coloration.
Any advice?