There is a small leak on the suction side at the junction of a Jandy Valve and PVC a bit in front of the pump. When pump is on there no leak (and only very small couple of bubbles). When the pump is off a paper towel wrapped around the PVC will be soaked in a few minutes.
Are there any good long term solutions (puddy etc..) besides cutting out the section and replacing it. Junction just just above ground so bit much room to work.
Are there any good long term solutions (puddy etc..) besides cutting out the section and replacing it. Junction just just above ground so bit much room to work.
Attachments
Last edited:
