Question for those using a Stenner:
What is your experience with the GPD specs on these pumps?
Today, I installed a Stenner 8.5 GPD Econ T. Unfortunately I had issues with getting the correct fittings to finish, but I did get it mounted and have the tank in place.
My pump is rated at 8.5 GPD. So, if I do the math right, I expected the pump to deliver about 16 oz of chlorine in 22 minutes. I did a test run and the pump, and it delivered about 21 oz of fluid in 22 minutes. I set it up to pump into a measured container.
The one variable is that it was pumping through an open tube, as I did not install the injection port on the tubing.
To anyone with experience, would the open tubing allow that much more flow?
What is your experience with the GPD specs on these pumps?
Today, I installed a Stenner 8.5 GPD Econ T. Unfortunately I had issues with getting the correct fittings to finish, but I did get it mounted and have the tank in place.
My pump is rated at 8.5 GPD. So, if I do the math right, I expected the pump to deliver about 16 oz of chlorine in 22 minutes. I did a test run and the pump, and it delivered about 21 oz of fluid in 22 minutes. I set it up to pump into a measured container.
The one variable is that it was pumping through an open tube, as I did not install the injection port on the tubing.
To anyone with experience, would the open tubing allow that much more flow?