Today was going to be the last swim so I set the heater to 89 and jumped in. We jumped in and had some fun. I checked the error messages when I got out and it read- sensor failure. As per the manual- Thermistor temperatures disagree by more than 2F. Also Water Sw Open. This may be because I was running the pump at a slow speed. I know these are new errors as I cleared the memory 2 weeks ago, and I have been checking. The sensor error was listed as the last error. I don't know about the sensor failure, what that means, how to trouble shoot, how to repair. Thanks. (The heater is listed in my signature, this is the new one I installed about 1 month ago.)
Sensor failure?
- Thread starter adl6009
- Start date
- Jun 7, 2017
- 9,966
- Pool Size
- 29000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Jandy Aquapure 1400
If it is still working fine then just ignore it. Temp sensors are "somewhat" consumables and typically easy to replace. Order one and replace it at some point.