Rusted diving board bolts

[Slowride]

I’ve got an older diving board that finally gave way. It looks like the bolts installed when the concrete was poured have rusted through. What’s the best way to get this diving board back up and working? Am I drilling new holes into the concrete for lag bolts or does the concrete have to come up and be re-poured with the bolts installed?

thanks in advance for any help.

 

[Texas Splash]

Maybe @jimmythegreek can help us confirm the best way to reattach?

 

[Rossterman]

It looks like it was simply installed with expanded anchor bolts. I’d drill out the hole and reinstall. Make sure you use anchors the proper legnth formthe required holding capacity.

 

[texasmax]

If I may, make sure to clean/get the dirt/dust out of the hole before the bolts go in so they can grab properly.

 

[sktn77a]

The SR Smith webside has instructions for drilling and epoxy gluing new bolts in your concrete. This will look better than cutting the concrete and replacing the rebar bolt jig. Don't cut any corners - it's a safety issue.

 

[jimmythegreek]

You can drill and clean the holes out then epoxy new anchors in if it has to stay in the exact same place. You can also drill new holes a few inches away and use sleeve expanding concrete anchors.