Resin cleanup???

trivetman

Bronze Supporter
Jul 14, 2017
817
Jenkintown, PA
Pool Size
24000
Surface
Plaster
Chlorine
Salt Water Generator
SWG Type
Hayward Aqua Rite (T-15)
We’ve got a mess. We had some resin/hardener left over from a project spill over the basement floor. To be more precise, it didn’t actually spill but started to leech through the plastic jug it was in.

I don’t care much about the stain but its pretty sticky still. So far Ive tried mineral spirits and acetone with limited success.
Any other ideas for cleanup?

im not sure if it was the resin or the hardener which leaked, but it was only one. They didn’t mix. I tossed them pretty quickly after it happened and forgot to look at the label.
 

Attachments

  • IMG_0904.jpeg
    IMG_0904.jpeg
    1.5 MB · Views: 17
What about *more epoxy* and one of these thingies ?

Screenshot_20250120_201537_Chrome.jpg


Or maybe an area rug ?
 
Ya know….maybe Ill just try the heat gun on it. Sometimes thats better than dealing with the solvents
Be careful with the heat gun on concrete. Sometimes you can heat up a small air pocket in the cement and it can pop a chunk of rock at you. Had that happen once, but was using a torch.
 
Thread Status
Hello , This thread has been inactive for over 60 days. New postings here are unlikely to be seen or responded to by other members. For better visibility, consider Starting A New Thread.