I have a spare VS500Z board that was made the same year as the old... but there is 1 difference where a jumper connection lands.
Does anyone know how to configure the new board with that connection going to Terminal W4? Photo with call-outs attached (red circles and yellow text)
LMK if there is any other configs I need ot change - other than swapping the chip and making sure the other jump connections are the same as the old board. Thx
Side Note: You can I had a board burned at the left heater connection point. It was a solid connect, no clue why it fried but all fuses were fine so no over amp. Lasted 4+ years. Very odd IMO.
thx for the help!
Does anyone know how to configure the new board with that connection going to Terminal W4? Photo with call-outs attached (red circles and yellow text)
LMK if there is any other configs I need ot change - other than swapping the chip and making sure the other jump connections are the same as the old board. Thx
Side Note: You can I had a board burned at the left heater connection point. It was a solid connect, no clue why it fried but all fuses were fine so no over amp. Lasted 4+ years. Very odd IMO.
thx for the help!