Replacement Pump Power Cord Too Short - Options?

Jump to latest Follow Reply
M

madams135

Member
Jun 23, 2024
8
NY
Hey all. I just pulled the trigger on a new Hayward Power Flo Matrix dual speed pump. 1.5 HP. This is replacing a failed unit of the same model, but a single speed 1HP. Unfortunately the old pump has a ~ 6ft power cord, while the new one only has a ~2ft cord. Oops. I was going to switch them out, but the 1HP used a 16 awg while the new pump came with a 12 awg.

My problem is that my power comes from a basement, leaves the house somewhere underground, and comes up through a fixed conduit sticking straight up with an outlet and cover. The new power cord says "do not use with an extension cord". Any solutions in mind? I really don't have the time, skills, or money to address the electrical supply situation. Thanks in advance for any help.
 
Well, you need to open the pump and replace the current whip with a longer 12 ga whip so maybe call a pool guy to do it for you? However it will take money to resolve this. At least for a longer whip whatever connectors you need to attach it to the power source.
 
TinFoilHat said:
Well, you need to open the pump and replace the current whip with a longer 12 ga whip so maybe call a pool guy to do it for you? However it will take money to resolve this. At least for a longer whip whatever connectors you need to attach it to the power source.
Click to expand...
Thanks for the response. It dawned on me after posting that I could probably just find a 12awg cord elsewhere and replace. I do have enough skill to do that.
 
If running 110v then maybe, but I wouldn't for a 220 v motor. I'm surprised that 1poolman1 with all of his experience is suggesting this. An orange cord from the motor to the power source would be quite the red flag for an inspector. Is the cord being hardwired to the source? Is it going to be in conduit? If yes to both then go ahead.
 
1poolman1 said:
TinFoilHat said:
If running 110v then maybe, but I wouldn't for a 220 v motor. I'm surprised that 1poolman1 with all of his experience is suggesting this.
Click to expand...

Get a 10', 12 gauge outdoor extension cord
Click to expand...

A #12 AWG copper wire can be used for circuits up to 20 amps. Most 230v motors are rated 20Amps. He suggested, clearly, 12 gauge.
 
You must log in or register to reply here.
Thread Status
Hello , This thread has been inactive for over 60 days. New postings here are unlikely to be seen or responded to by other members. For better visibility, consider Starting A New Thread.
Top Bottom
Back
Jump to latest Follow Reply