Relative ideal water level for skimmer

bob19

Member
Mar 15, 2022
12
Tucson, AZ, US
Pool Size
10000
Surface
Plaster
Chlorine
Liquid Chlorine
Don,

Not sure I have a direct answer to your question but...

For me, skimming works best when the water level is close to the bottom of the skimmer mouth.. It works worst when the water is at the top of the skimmer mouth.

The problem is that if you run near the bottom of your skimmer mouth, you run the risk of the water dropping too low and the skimmer running dry.

That is why the middle of the skimmer is recommended.. A balance between good and evil.. :mrgreen:

As long as you watch the water level, or have an auto fill, then in my mind lower is better for skimming.

Seems to me that since all skimmers are not created equal, that this is one of those situations where the pool owner just has to experiment with it, and adjust the level to suit their specific pool.

Thanks,

Jim R.
I'm with you Don,

I used to keep my levels halfway or above. However, after observation, I noticed I collect much more debris when my level is 1/4 ish. I think it sucks air every now and then but it's so little am I really doing that much damage to my pump? My skimmer is a 3/4 hp single speed which I just had the bearing and seal replaced. I like having my skimmer do most of the skimming! Like you said, every pool and skimmer is different.

Bob
 
Meaning if you keep it lower than recommended and then the water leveler goes on the fritz that could lead to the filter sucking air from the skimmer.
That's what I thought you meant, just wanted to be sure. Don't have an auto leveler. Don't really need one, that task just falls on to me. I keep a close on it. I really notice the difference keeping it at the lower level.
 
Thread Status
Hello , This thread has been inactive for over 60 days. New postings here are unlikely to be seen or responded to by other members. For better visibility, consider Starting A New Thread.