Re: iAqualink aux 4 thru 7 lights showing "on" on the in house panel
Having the same aux lights issue as everyone else with my RS4 inside controller. I also have the Jandy iAquaLink installed. Simple shut off of the power or reset button on the larger control panel outside seems to return things to a normal state on the RS4 inside controller. Then after a few days it does it again with the aux lights coming on.
Spoke to Jandy tech support today and they told me it needed a 1K Ohm resistor. Would not tell me the exact location of where to install it. Said, that it needed to be done by a qualified technician. I'm a avid do it yourself fix it guy so shouldn't be a problem for me to install it. Just need to know where it goes. So, from what I understand the 1k resistor needs to be installed where the #1 and 2 wire ports/ connector essentially where the (red, black) wires are connected on the back side of the RS4 or RS8 unit. If someone has a picture of this it would be greatly appreciated, just so I have it correct.
Having the same aux lights issue as everyone else with my RS4 inside controller. I also have the Jandy iAquaLink installed. Simple shut off of the power or reset button on the larger control panel outside seems to return things to a normal state on the RS4 inside controller. Then after a few days it does it again with the aux lights coming on.
Spoke to Jandy tech support today and they told me it needed a 1K Ohm resistor. Would not tell me the exact location of where to install it. Said, that it needed to be done by a qualified technician. I'm a avid do it yourself fix it guy so shouldn't be a problem for me to install it. Just need to know where it goes. So, from what I understand the 1k resistor needs to be installed where the #1 and 2 wire ports/ connector essentially where the (red, black) wires are connected on the back side of the RS4 or RS8 unit. If someone has a picture of this it would be greatly appreciated, just so I have it correct.