Question for Jandy Aqualink users of "All Button" and/or "One Touch" wired, wall-mount panels

[stbasil]

For those of you who use the above hard-wired wall-mount controllers on your Jandy controller, what does the display show when it is just sitting there on your wall? IE, does it show basic pool parameters, such as water temp , air temp, etc.?

Background: I had started another thread (thank you to those who responded!) regarding some compatibility questions for my newer Aqualink pool controller as to whether it would support one or both of those wired panels. Right now, I have all wireless stuff (hand held "PDA" and phone app), but was thinking about adding a wired, wall controller, but only if it shows useful information continuously when not pressing any buttons on it.

Thanks for your inputs!

 

[ajw22]

I have the All Button control panel with rev HH firmware. The display scrolls through date, time, air temp and water temp.

 

[stbasil]

Thanks for your feedback, Allen--very helpful!

Anyone out there using the Jandy One Touch wall control panel?

 

[ajw22]

I think @PoolGate uses the One Touch.

 

[HEaton02]

I have the Jandy One Touch wall control panel. It scrolls through date/time and pool/air temp, then what is currently running (i.e. filter, heater etc.) and then shows the speeds of the pumps that are running. Happy to send/share pics or a video if you want.

 

[stbasil]

Thank you, HEaton02! Just what I needed to know. Sounds like it is similar to the display on my hand-held wireless PDA, once it is turned on and connects. The PDA turns off automatically after a few minutes to save the batteries, of course.