Hello last night my pump was running all night and I turned it off this morning and after I turned it off it didn’t want to turn on again. I turned off the power to the pump through the break multiple times and played with the OmniLogic screen and it still doesn’t turn on and the error it shows says no water flow flowsensor. Please help thank you.
Pump not running, water flow flowsensor error
- Thread starter MichalLen
- Start date
- May 3, 2014
- 62,705
- Pool Size
- 6000
- Surface
- Fiberglass
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-40
Hayward OmniLogic - Further Reading
www.troublefreepool.com
See if anything in the article above helps.
Can you fill out your signature? Create Your Signature - Further Reading