Need some assistance with my pool pump. I am trying to hook my new pool pump and it won’t turn on. It’s a Doheny 1.5hp 115/230v pump, it’s replacing the very same pump so the electrical should all be the same. I have the wires connected to the 1 and 3 terminals and have power going to the pump but it will not turn on. I know I am just missing something, need some help please. Thanks in advance.
Pool Pump won’t turn on
- Thread starter jhudson029
- Start date
- Jun 24, 2021
- 16,930
- Pool Size
- 29000
- Surface
- Vinyl
- Chlorine
- Salt Water Generator
- SWG Type
- CircuPool RJ-60 Plus
Are you trying to wire 115 or 220?
115, rotate the black dial counter clockwise in lower right to 115. Ground goes to GRD (upper right).
Then the black and white goes on the two screws on brass. Black on top.
230:
Leave black dial where it is. Ground is the same, the two line wires to screws on brass
115, rotate the black dial counter clockwise in lower right to 115. Ground goes to GRD (upper right).
Then the black and white goes on the two screws on brass. Black on top.
230:
Leave black dial where it is. Ground is the same, the two line wires to screws on brass