Good Morning All,
Hope everything is going well!
I have an Pool Pilot Digital Nano AutoPilot which is giving me a "Warning! Check/Clean Cell" for a few weeks. I have cleaned the cell per manual with 1:4 water & Muriatic Acid ratio but the Warning is still there. BTW contacts had green corrosion which I cleaned & it was shiny clean afterwards. Just in case, I have ~14000 Gallons Pool.
Other Specs when I tested AutoPilot are as below:
26 Volt 3.3 Amps
Salt: 3300ppm
Temp: 84F
Amp-Hours: 57575
Power Level 5A
The Water Readings are as under (Done just after a lot of rains recently):
Chlorine: 0ppm
pH: >8
Total Alkalinity: 125ppm
Ca Hardness: 220ppm
Stabilizer: 60ppm
Total Dissolved Solids: 4800ppm
Salt: 3200ppm
What needs to be done here?
Thank You:
Hope everything is going well!
I have an Pool Pilot Digital Nano AutoPilot which is giving me a "Warning! Check/Clean Cell" for a few weeks. I have cleaned the cell per manual with 1:4 water & Muriatic Acid ratio but the Warning is still there. BTW contacts had green corrosion which I cleaned & it was shiny clean afterwards. Just in case, I have ~14000 Gallons Pool.
Other Specs when I tested AutoPilot are as below:
26 Volt 3.3 Amps
Salt: 3300ppm
Temp: 84F
Amp-Hours: 57575
Power Level 5A
The Water Readings are as under (Done just after a lot of rains recently):
Chlorine: 0ppm
pH: >8
Total Alkalinity: 125ppm
Ca Hardness: 220ppm
Stabilizer: 60ppm
Total Dissolved Solids: 4800ppm
Salt: 3200ppm
What needs to be done here?
Thank You:
