Good morning, just a quick question. This morning I accidentally added too much acid. I have my PH at a 6.8. I am running waterfall to try and bring up. Any suggestions??
PH
- Thread starter Lizzard6975
- Start date
- Jun 22, 2014
- 48,810
- Pool Size
- 17888
- Surface
- Fiberglass
- Chlorine
- Salt Water Generator
- SWG Type
- CircuPool RJ-45 Plus
TA is at an 80. I was putting in acid to bring the TA down as it was at 90 when I tested this morning.
- Jun 22, 2014
- 48,810
- Pool Size
- 17888
- Surface
- Fiberglass
- Chlorine
- Salt Water Generator
- SWG Type
- CircuPool RJ-45 Plus
I think you should hold-off on anymore chemicals for a while and let the water balance itself out a bit. With your aeration, that TA should help the pH get back into the mid 7s just fine. If you don't see the pH rising by the end of the day let us know.
PH is up to 7.2. It will continue to go up a little. I learned a lesson. Thought I had ruined everything. Thanks for help.
Similar threads
