Hi Folks, I've been using the Protocol Adaptor (PA) for several months without issue. Now it will not re-connect to my network. The red light is on but the two network lights are out. I know the Ethernet line is good as I can connect it to my TV and it provides ethernet signal. I tried rebooting and resetting and no change. The system has a direct 4 wire connect to my outdoor panel so it's not a wireless issue. Any suggestions? Is the unit damaged? Thanks, Paul
Pentair Screenlogic 2 Protocol Adapter will not reconnect
- Thread starter pjscrs
- Start date
- Jun 22, 2014
- 52,018
- Pool Size
- 17888
- Surface
- Fiberglass
- Chlorine
- Salt Water Generator
- SWG Type
- CircuPool RJ-45 Plus
Good morning. I see your question just sitting in the unanswered list. Did you ever get an answer or figure this out?
By the way, welcome to TFP!
By the way, welcome to TFP!