PDA to iAqualink

[kjmoriarty]

I want to convert my PDA to the iAqualink so I can control my pool from my iPhone. From what I've read, I will need to change out the circuit board in the power center. Is this very difficult to do? I'm not much of an electrician, but I am very good at following instructions as long as I understand the terminology. Any advice?

 

[HermanTX]

You would need to purchase the iQ30-RS kit. It has both the PCB and the new 3.0 antenna needed for the web interface.

Unfortunately Jandy does not sell the kit online but you can find some sellers on EBay and obviously from different pool supply stores. Some stores will only sell if they provide the service. It is easy to change out the PCB and then mounting the antenna and running wire to the PCB.