OmniLogic issues with heater and pump

[ecac]

Hi,
Very new to all this pool stuff. We had our OmniLogic wired and we just went through the setup. Unfortunately when I go to add the Filter pump, which is a Super Pump VS700 1.65hp 230v, when I select VSP its not coming up with a hardware address to select. One I go back and select Single Speed it seems to work fine.

Does anyone know why this might be happening? Thanks!

 

[ecac]

Hi,
We have a Hayward heater and I have added it in the OmniLogic panel. Problem is I can't control the heat settings via the OmniLogic panel just through the heater itself. I am not sure if this is a wiring thing, or any other ways I can troubleshoot this. Any suggestions would be greatly appreciated.

Thanks in advance.

 

[twillux]

Hi,
We have a Hayward heater and I have added it in the OmniLogic panel. Problem is I can't control the heat settings via the OmniLogic panel just through the heater itself. I am not sure if this is a wiring thing, or any other ways I can troubleshoot this. Any suggestions would be greatly appreciated.

Thanks in advance.

Ecac, see this thread; you need to put the heater in bypass mode, which allows it to take a remote temperature set point from the OmniLogic controller: OmniLogic app won’t change pool temp

 

[twillux]

Very new to all this pool stuff. We had our OmniLogic wired and we just went through the setup. Unfortunately when I go to add the Filter pump, which is a Super Pump VS700 1.65hp 230v, when I select VSP its not coming up with a hardware address to select. One I go back and select Single Speed it seems to work fine.

Does anyone know why this might be happening? Thanks!

Ecac, not sure if you got this working or not. The VSP’s require both 240V power to run the motor as well as a low voltage connection to control the pump from the controller. If the OmniLogic isn’t detecting the VSP, check the wiring and the dip switches on the pump; here is the page from the manual for reference.