No Pool or Air Temp readings OmniLogic

[WesL]

I just installed my new pool and OmniLogic Panel. Everything is working fine with the exception of my sensors.

Both my air temp and Pool temp is not displaying. I’m not sure if the system is supposed to show a flow but I’m not getting any flow alarms.

Any advice would be appreciated. I’m very new to this pool ownership things

 

[1poolman1]

I just installed my new pool and OmniLogic Panel. Everything is working fine with the exception of my sensors.

Both my air temp and Pool temp is not displaying. I’m not sure if the system is supposed to show a flow but I’m not getting any flow alarms.

Any advice would be appreciated. I’m very new to this pool ownership things

Are all the temp sensors installed and the wires in the proper location on the board? Is the connection plug actually installed on the board and not left hanging in the box? They should be connected to the terminal buss at the top left of the image on page six of the attached manual:

 

[WesL]

Are all the temp sensors installed and the wires in the proper location on the board? Is the connection plug actually installed on the board and not left hanging in the box? They should be connected to the terminal buss at the top left of the image on page six of the attached manual:

Yes. Everything is terminated on the board appropriately as well as fine through the configuration to make sure they are allocated in the proper location