Next step for AGP with foam bottom

[NeoshoPool]

Hi,

What’s my next step? Currently I have all the pavers on top of grade leveled within 1/4 of each other. Was planning on putting foam under rails(same height as paver), but I think that isnt recommended. Plus I don’t know how I would uncoil wall without damaging the foam. Do I need to sink the pavers flush/level with grade and then install pool walls then put foam inside pool?

 

[Texas Splash]

That's a great looking set-up you have there. I suspect by now you're already onto the next step(s), but figured I'd post to see if you still needed help.

 

[NeoshoPool]

That's a great looking set-up you have there. I suspect by now you're already onto the next step(s), but figured I'd post to see if you still needed help.

Yes, I’m waiting for some replies to my question. Should I put pavers flush with grade and put foam only on the inside of pool? It’s going to cool down Sunday, so hopefully can put pool up then.

 

[Texas Splash]

We'll keep this thread moving then. From another post I found ....

The pavers need to be recessed into the ground so the top is flush with the surrounding soil. Use a hand tamper and tamp the soil around each block to help pack the soil in around them, ensuring the finished height is even with the soil.

Maybe another AGP owner will chime in with thoughts to help.