Need a Compool temp controller knob!

[midmodonhillwood]

Good morning!

I can’t be the only person in this huge community with a vintage Compool wall mounted controller!

Ours new house has one in the bedroom and it works, but it’s missing the temperature control knob and I’d like to have one!

It’s old but I like it and was able to program it! I put a new coin battery in it and I’m constantly updating the minutes as they fall behind a couple each day!

If anyone has one just laying around and can part it out I’d like to pay you for it! I don’t know if the knob can be removed separately?

 

[mas985]

I can't tell from the picture but is the shaft below the panel surface or does it come above it. There are retrofit dials that should work ok if you can find the right one.

https://www.amazon.com/s?k=dial+knob+replacement&crid=2RBXTSVPPP13V&sprefix=dial+knob%2Caps%2C133&ref=nb_sb_ss_ts-doa-p_1_9

 

[midmodonhillwood]

I can't tell from the picture but is the shaft below the panel surface or does it come above it. There are retrofit dials that should work ok if you can find the right one.

https://www.amazon.com/s?k=dial+knob+replacement&crid=2RBXTSVPPP13V&sprefix=dial+knob%2Caps%2C133&ref=nb_sb_ss_ts-doa-p_1_9

There isn’t anything sticking up above the panel. I’m not sure if the knob is missing and just be pressed back in/on, or it it was broken off and the shaft was also damaged!

Thank you for the reply and suggestion!!

 

[mas985]

If the shaft is broken, you may need to glue a new shaft on to the end of it. A plastic rod with a hole drilled in the center might work.