Sigh.
Believe it's a two-year-old T-Cell 15. Board was also relatively new -- around the same time.
T-Cell had a lot of scaling. A lot. I soaked it in probably 2/7 mixture (yes, I was off from the 1/4 I'm guessing) for 15-30 minutes. Got all the scaling off.
Readouts on board were no good going in. And still no good.
Average salt = 100 or 200. And I had it tested today. It was 3000, according to Leslies. And I know it was high last summer because I was getting bad readings even then and added too much salt.
75 degrees
32.5 cell voltage
0 amps
31p
0 instant reading
88-2 program code <----- is that even legit?
r8.80
Crazy thing is it says "Generating", which it obviously isn't.
Inspect cell light is solid orange.
Check salt is solid red.
Guessing I either need a new board or new cell or both. Please advise. Assuming that if I call a pool guy, I may as well just replace both. So I'm hoping someone can point me in best direction.
Thanks,
Matt
Believe it's a two-year-old T-Cell 15. Board was also relatively new -- around the same time.
T-Cell had a lot of scaling. A lot. I soaked it in probably 2/7 mixture (yes, I was off from the 1/4 I'm guessing) for 15-30 minutes. Got all the scaling off.
Readouts on board were no good going in. And still no good.
Average salt = 100 or 200. And I had it tested today. It was 3000, according to Leslies. And I know it was high last summer because I was getting bad readings even then and added too much salt.
75 degrees
32.5 cell voltage
0 amps
31p
0 instant reading
88-2 program code <----- is that even legit?
r8.80
Crazy thing is it says "Generating", which it obviously isn't.
Inspect cell light is solid orange.
Check salt is solid red.
Guessing I either need a new board or new cell or both. Please advise. Assuming that if I call a pool guy, I may as well just replace both. So I'm hoping someone can point me in best direction.
Thanks,
Matt