I just started on a project to remove my 33 year old RayPak and install a new Pentair Max E therm 400HD. Once I got the new concrete equipment bases in an leveled leveled I started placing the equipment. When I got to the Max E therm I got it placed on the bases and the thing wobbles like a toilet on an uneven floor. I will indeed use toilet shims to get this thing stable unless someone else has had the same problem and a better- more elegant solution. Glad I have 3 more days to get this buttoned up.
Max E Therm is wobbling- New Install
- Thread starter LV Desert Pool
- Start date
- Jul 21, 2013
- 65,275
- Pool Size
- 35000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-60
Have you looked to see if anywhere on the base is high and can be trimmed down? Is there some edge that was not correctly trimmed?
@1poolman1 @wireform
@1poolman1 @wireform
- Jul 21, 2013
- 65,275
- Pool Size
- 35000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-60
I'm pretty sure these are made in a mold. I ran a straight edge at every angle- to see if in fact there were high spots- nothing high or low to the naked eye. I have some synthetic rubber isolating pads that I think will do the trick.
If the base of the filter is straight then the only thing that could be not straight and flush across is your pad/slab. One or the other.
