I replaced the circuit board to fix my problem with temp reading, but now the heater will not ignite. The igniter has a ohm reading of 130. It cycles thru 3 or 4 times then the error message. The ignition module has no flashing led and was replaced 4 years ago. Last time I had this problem the module was replaced.
Mastertemp 300 ING ERR
- Thread starter dogcomputer
- Start date
- Jul 21, 2013
- 65,526
- Pool Size
- 35000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-60
A new igniter resistance is 50 ohms.
I would replace the igniter as a start.
www.troublefreepool.com
I would replace the igniter as a start.
Pentair MasterTemp Heaters - Further Reading
www.troublefreepool.com