Master Pools In Floor Gear Parts

[tm georgia]

I'm probably one of the few people who still have the old Master Pools In Floor 5 port valve system with gears. I've kept this system going for 20 years. I usually have to change out the gears once or twice a year. Now I can't find gear parts. They are discontinued. Does anyone still have this system? Do you know where to buy parts?

If I can't find parts I can replace it with one of the new valves that don't use gears. I know this is inevitable and will probably save me money in the long run. Till then, I would like to keep it going with the gears.

 

[proavia]

Since it's discontinued, you may have to change the entire water valve.
Contact these guys and chat with them about possible options.

Master Pools 5 Port Valve Gear Plate Assembly

Gear Plate Assembly for Master Pools Five Port Turbo-Clean Actuator Water Valve.

www.infloorpoolparts.com

 

[TimmyR]

Any updates here? I have the exact same piece of equipment on my pool and the gear assembly has completely failed. I"m thinking I may pull it out and run it without it if I can get it to reseal until I can get a new one.

 

[JamesW]

Find an MPG Member | Local Pool Companies | Master Pools Guild

If you're looking to start your dream pool project, Master Pools Guild is your go-to network for trusted local pool companies. Find your local MPG member today!

www.masterpoolsguild.com

 

[JamesW]

In Floor Cleaner Parts - INYOPools.com

In Floor Cleaner Parts – INYOpools.com has the largest selection of swimming pool and spa replacement parts with over 70,000 parts in stock. Order today and save!

www.inyopools.com

 

[TimmyR]

Thanks James. I've scoured the links for the gear assembly and as it's discontinued it's not available. The link is one of my two local pool retailers and I planned to call them tomorrow anyway. It looks like I'm stuck until I can get it looked at. I'm guessing its a full replacement.

 

[TimmyR]

Well, I managed to fix it. It turns out one the gear pin did not break, it just slid down so one of the cogs would not stay on. I'm back in business. I still feel like I'm on borrowed time and perhaps replacing it is a smart move, but it can now wait until the end of the season.

 

[Benny_B]

Just today mine stopped turning. Found a bad gear (second from the bottom, middle sizes one) @TimmyR glad you got yours going again.
Any one find some place to get replacements or have some good gears left over from a replacement job?

 

[proavia]

Just today mine stopped turning. Found a bad gear (second from the bottom, middle sizes one) @TimmyR glad you got yours going again.
Any one find some place to get replacements or have some good gears left over from a replacement job?

You may want to call the guys linked in post #2.