I am new to pool ownership, we have been in this house with a pool for about 8 months. In the past 2 weeks, I am getting an error code as mentioned above. We have just installed a new 28 Salt Cell and the error code is still blinking. I reinstalled the salt cell... no change. My pool is about 13,000 gallons, and I have the following info on the Autopilot when running the test... Purifier 54% on, Salt +3600ppm, temp 87, Cell + 0V 0.2A ( yesterday this read 34v 0.2A) amp hours = 26915.... HELP!!!! Thanks in advance.... we also just changed the salt in the filter...
Low Amps: Cell?? Error Code on my Autopilot
- Thread starter toms island
- Start date
- Jul 21, 2013
- 66,008
- Pool Size
- 35000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-60
What model Autopilot & cell do you have?
See Volts & Amps Guide - AutoPilot Website
See the five steps to do before you test the unit:
When you own a SWG you need to have a separate salt test kit like the K-1766 Taylor Salt Test to check actual salt level against what the cell says.
See Volts & Amps Guide - AutoPilot Website
See the five steps to do before you test the unit:
When you own a SWG you need to have a separate salt test kit like the K-1766 Taylor Salt Test to check actual salt level against what the cell says.
Last edited:
Do you have the correct cell selected in configuration?
What power level are you using?
What power level are you using?