Looks like I'm needing a new main board for my Hayward Pro Logic

[danjaymor]

Displaying the "high salt/high voltage" message. I did run the diagnostic menu check and getting a reading of 40.5 V, so it's apparently time for a new main board.

Does anybody have guidance for me on a good source for the GLX-PCB-PRO board? My pool guy wants 1000 bucks to replace, I know that he needs to make some money but at a quick glance it looks like I can get a replacement for under 600 dollars online?

 

[mas985]

What does the AC voltage read on the transformer yellow leads?

 

[JamesW]

I did run the diagnostic menu check and getting a reading of 40.5 V

That is usually damage to a solder point.

Check the back of the board for obvious damage.

Touch up any bad solder points.

 

[danjaymor]

I saw that recommendation from you on another thread. Thank you, I'm actually going to take a peek!

 

[JamesW]

High Salt/Amps reading on brand new Hayward T-15 cell

I just replaced my old Hayward T-15 cell with the exact same model. (setting is correct in my diagnostics) When I first started running the pool after replacing it the chlorinator would shut down with the dreaded High salt/Amps message. This was no shocker, as I am pretty sure when most...

www.troublefreepool.com

Aqua Logic Salt Too High - Cholrinator Off High Salt/Amps

I just replaced my T-cell 15 Turbo cell with a new T-cell 15. When the system begins to run I get this message, "Chlorinator Off High Salt/Amps." Then later in the messages I get, "Check System High Salt/Amps." I checked the instant salt reading and it is 4800, which I know is way too high. I...

www.troublefreepool.com

New Guy's T-15 problem

I found y'all while researching an issue with a Aqua Logic Goldline Chlorinator cell replacement. Replaced a T-15 with a T-15 and got the dreaded Chlorinator off, High Salt/Amp shutoff message. I found your thread on a resolution involving the K1 relay solder/connection by DJConn. Can...

www.troublefreepool.com

I don't really know how it gets the high voltage, but it is a relatively common problem that can usually be fixed with a dab of solder.

The high voltage causes the high amperage and shutdown.

 

[Laura596]

That is usually damage to a solder point.

Check the back of the board for obvious damage.

Touch up any bad solder points.

How do you touch up the bad points?
do you need to remove the old solder prior to putting in new? And how do you remove the old solder?

 

[ajw22]

How do you touch up the bad points?
do you need to remove the old solder prior to putting in new?

No, just reheating the solder joint with some flux on it is usually sufficient

And how do you remove the old solder?

Lots of videos on YouTube for soldering and desoldering.