Anyone using a PVC union made by American valve?
Each year after removing and going to reinstall the next spring,I remove the o rings and apply some silicone grease to them
Also, every so often a few seem too large and will not go back in slot.
The union I purchased at Lowes but is now discontinued there as well as not showing up on mfg. website.
American Valve, Lowes # 188223
number molded on one slip end on sleeve is 240-121 DN40 1 1/2"
I would just like to get a few o rings instead of swapping out the union for right now.
Thanks
Each year after removing and going to reinstall the next spring,I remove the o rings and apply some silicone grease to them
Also, every so often a few seem too large and will not go back in slot.
The union I purchased at Lowes but is now discontinued there as well as not showing up on mfg. website.
American Valve, Lowes # 188223
number molded on one slip end on sleeve is 240-121 DN40 1 1/2"
I would just like to get a few o rings instead of swapping out the union for right now.
Thanks