Wife and I just installed a 16x 32 overlap liner in our old above ground pool. We have been able to work out all of the wrinkle issues on the bottom but have an issue with the liner walls specifically the lopsidedness of the print from one side compared to the other side? We have taken it down and tried to rotate the liner it seems to be tighter in the corners
Liner install issue
- Thread starter Nmallard
- Start date
- Jun 22, 2014
- 47,908
- Pool Size
- 17888
- Surface
- Fiberglass
- Chlorine
- Salt Water Generator
- SWG Type
- CircuPool RJ-45 Plus
Did you two ever manage to wrestle that liner into submission? 