Liner came out of coping

[Canadian guy]

hello, just got a pool in a house I purchased last fall. When opening the pool today I saw around 3 feet of liner came off the coping. I used the warm water method to get it back into place but the issue is when I got to the end there's roughly an inch more liner than coping. So I'm assuming during the task I ended up stretching the liner a little left instead of straight up. So my question is do I need to pull it out and restart or can cut a piece of the liner out at the bead to make it fit better?

 

[PoolStored]

Welcome to TFP!!!

Please don't cut the liner.

Go back and redo it. As you are doing it, keep pulling the liner taught. e.g. If you start on the left side of the un-beaded section and work right, push it into the track with a left pressure bias to keep the liner taught to the right...Make sense?

 

[Canadian guy]

Welcome to TFP!!!

Please don't cut the liner.

Go back and redo it. As you are doing it, keep pulling the liner taught. e.g. If you start on the left side of the un-beaded section and work right, push it into the track with a left pressure bias to keep the liner taught to the right...Make sense?

It does. Thank you!