Leg buckled on intex ultra frame!

[bsepper]

I replaced some rusted legs on my intex ultra frame and refilled... everything was running smoothly with the salt water until this happened I propped up the two old legs by the bent one, hoping it will be alright until I drain again. Must I drain completely again?? I couldn't replace the others without completely draining because I wasn't strong enough to lift but hoping the whole the won't collapse tonight!! Any help would be appreciated!

 

[kellyfair]

Oh wow. That is definitely not going to hold up. I’m guessing you were very off level and the leg was not straight to begin with.

If you can, I’d drain some tonight just in case. Doesn’t have to be all of it, but to take pressure off that leg.

 

[Simple1]

I have the same issue only 4 are rusted completely thru was working on tile floor inside so took some thin set and pea gravel packed that as best I could inside up the leg and down and all around on the outside so far so so good 4 months and holding still lol these cheap pools are just that intex thinking about getting fence posts
and using those

 

[cj133]

When i put up an Intex pool I need to go around a few times and pull the legs outward as it filled. Mine was very very level but things needed to move as it filled.