Jandy Sensor Failure?

[Cowboy46]

I have a Jandy AquaPure system with a PURE1400 cell.
I get failure codes 175 and 182.
Of course the Service light is on.
The screen says Flow, but the flow light is not on.
When I press the Salinity button, it shows --.
When I press the Pool Temp it bounces around from 36 to 42 F. Not sure what the actual water temp is but guessing around 80.
The sensor has 2 buttons. The temperature probe is in the pipe between the pump and the filter.

I did the board test:
Salinity + R-Temp + C, I got 3.2 when it says it should be 2.8.
Salinity + R-Temp + D, I got 74 F
H-Temp + C + A, I got 91 F
Does that mean the board is O.K?
How do you bring it back to the default settings if it was calibrated?

I traced the flat cable from the Sensor to the Power Center and found a crack in the insulation, so I will replace the sensor.

Just curious if the board is O.K. and about the 2-button sensor with the separate temp probe.

Thank you,

32,000gal Gunite IG; Jandy PHPF 1.5 HP, PureLink1400 WPS SWG, AquaLink RS, CL580 Cartridge Filter; Dolphin Cleaner; TF-100 Test Kit w/SpeedStir

 

[ajw22]

Your board sounds fine.

Fix your pool water temperature sensor and get a good reading.

 

[Cowboy46]

Your board sounds fine.

Fix your pool water temperature sensor and get a good reading.

So, I need to replace the temperature probe as well as the sensor?
In the Jandy AquaPure SWG - Further Reading I found on this site, it says there is a Jandy tri-sensor which measures water flow, salinity, and water temperature. Is that for a newer system than mine?

 

[ajw22]

So, I need to replace the temperature probe as well as the sensor?

Your system has two temperature sensors. One at the Aqualink water sensor in the pipe and one for the Aquapure in the tri-sensor.

Show me which display the temperature is bouncing around.

What does Aqualink say the water temperature is?

In the Jandy AquaPure SWG - Further Reading I found on this site, it says there is a Jandy tri-sensor which measures water flow, salinity, and water temperature. Is that for a newer system than mine?

Old and new sensors both have the tri-sensor. Just different designs.