Jandy JXI Turning Off?

[f30er]

I have a Jandy JXI that's a little over a year old so out of warranty. The problem I'm seeing is it'll turn on, stay on for a few minutes, and then turn off. And repeat endlessly. It'll get the temp up eventually but takes forever. I had a tech come look at it and there's no codes so he spoke with Jandy who suggested a new Ignition Control Module.
I cleaned the filters today really good and it's still doing it. Other suggestions?

 

[ajw22]

Check the thermal regulator valve and bypass valve.

I doubt your problem is the ICM.

Jandy JXI Heaters - Further Reading

www.troublefreepool.com

 

[f30er]

Thanks!
Any links on how to check them or just replace them? Tried searching Youtube but couldn't find anything.

 

[ajw22]

Start by visually looking and handling them. You should see if they are broken or corroded.

Thermal regulator can be put in a pot of water and heated to see what temperature it opens. The Pentair thermal regulator opens at 120F and I am not sure about the Jandy. There should be its temperature stamped on it.

 

[f30er]

Start by visually looking and handling them. You should see if they are broken or corroded.

Thermal regulator can be put in a pot of water and heated to see what temperature it opens. The Pentair thermal regulator opens at 120F and I am not sure about the Jandy. There should be its temperature stamped on it.

Should I be concerned that after opening it up today, there's nothing there?