We just bought a home with an existing Jandy Auqapure PLC 1400 SWG. I had to replace the control unit so that is brand new. The cell will turn on and will run but then goes into "Cell Reversing" mode and never comes out. I have no FC in the pool and cant keep it running even on 100% for more then a couple hours. It looks like the cell is from 2017 and was not used for 2020 season until this year. I also took it apart and there is no scaling inside at all. Any ideas what I should look for?
Jandy Aquapure Stuck on Cell Reversing
- Thread starter rd383
- Start date
- May 3, 2014
- 59,702
- Pool Size
- 6000
- Surface
- Fiberglass
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-40
Jandy AquaPure SWG - Further Reading
www.troublefreepool.com
I do not see that specific issue discussed in the Wiki, but there is a link to a troubleshooting guide.