Jandy Aquapure runs for 5 seconds on powerup then shuts off

[mtesh73]

Hello, my Aquapure runs for 5 seconds until it shows the 00 chlorine and then beeps and shuts off. Any suggestions? I had just taken the pool offline to clean the filters after a marathon SLAM, that I am still undertaking. I am assuming the whole Aquapure control system will need to be replaced. I am thinking about abandoning it and using liquid chlorine from this point forward.

 

[mtesh73]

I just tested the salt level with the Taylor test kit and it is 2800, when I first opened the pool 3 weeks ago the Taylor test kit read 2000, I added the normal 4 bags of salt and the SWG read 3.4. I did not test the salt further with the Taylor test kit because 4 bags is usually what it takes to keep the SWG happy. I know that if the level is too high or too low normally there will be an error message on the screen. I am not getting any mesages, just the power being cut after 5 seconds.