I have an Aqua Rite SWG model X296. When I turn the pump on the no flow light flashes as it normally does and the salt reading shows. After about a minute the no flow light goes off and the generating light comes on for about 10 seconds and then goes off. The power light never comes on. After doing some reading I'm hoping that it's just the thermistor. I looked at it and don't see any cracks, etc. I haven't taken the board out yet to see if there are any burn marks on the back. I did check the resistance with the power off to the board and got a reading of about 2.5 ohms (if I'm reading my multimeter correctly). Would that indicate a problem? Just trying to see if I should order a replacement and solder it myself, which I'm comfortable doing, or if that's a good reading and not my problem. Thanks in advance for any input.